Crib Sheet Tutorial

Making your own crib sheets is less expensive than buying  sheets.  The sheets are larger than skimpy store-bought sheets so it's much easier to change them on a crib.  Believe me... it's been over 35 years and I still remember wrestling with a skimpy crib sheet in the middle of the night, trying to get it on the mattress when I was tired and the baby was crying.

To make one crib sheet, you will need:

• 2 yds of fabric (I used cotton flannel because it's soft and cooler in the summer and warmer in the winter)
• 90 inches of 1/4" or 3/8" elastic

Match selvedges and corners of flannel, folding into four layers.

Cut out a 9 inch square.  I used pins to mark the cutting line across the flannel and cut to that line.

If you are making more than one crib sheet, use the cut out squares as your pattern on the next sheet.

 

 

Save the cut out corner squares to make a baby quilt to match the sheets or save them to make a quilt for another baby!

Open folded fabric...

...and match edges of cut out corners, right sides together.  Sew 3/8" to 1/2" seam.  This makes the sheet corners sturdier at a stress point.  Back stitch at the top of the corner seam.

I serge the corner seam edges to prevent raveling/fraying.  If you don't have a serger, you can use a zigzag stitch on these edges to finish them.

After corner edges are all finished, open up sheet and serge/finish all edges of the sheet.  I do this because it's easier/faster when I sew the casing for the elastic.  Serging the edges also cuts off all the  fuzzy selvedges as well.

Turn serged/finished edges of crib sheet about 1/2" to 3/4" toward the inside and sew close to the finished edge.  If you decide not to finish the edges of the crib sheet, fold under about 1/4" and press.  Then turn under the 1/2" of fabric and sew down.

Leave about a 6" opening on the casing on one side of the crib sheet to insert the elastic.

This is a bodkin.  I've had it since the early 1970s at the latest and I don't know what I would have done without this tool over the years.  Not only does it make inserting elastic in casings easy, it can be used to repair drawstrings in shorts or sweatpants, leading your grandchildren to think you can fix anything!

If you don't have a bodkin, you can use a safety pin to insert the elastic in the casing.


Fasten bodkin or safety pin to one end of elastic and insert into casing.

Thread elastic through casing, pinning the end of the elastic to the crib sheet near the opening.  This prevents you from pulling the elastic too far into the casing where you can't get to it, thus having to pull the elastic out and start over!

You will have to move fabric by hand, pulling elastic along the casing as you thread it through.  Once you have the elastic back to the opening...

 ....sew the ends of the elastic together.  I overlap the ends about 2 inches and use a zigzag stitch so there will be some give.  This will prevent threads from popping where you sewed the ends together.

 Stretch the fabric to pull the elastic into the casing and stitch down the casing opening.

And now you have a crib sheet!

It took me a little over two hours to make all three crib sheets, which included taking photos.

It makes me smile to think of Jamie's little boy sleeping on these sheets and I know his mother will appreciate them.

If you have any questions, just let me know!